Menu

PDF version

Technical Data Sheet (TDS)

R741 Xtrem-Link Mono

Adhesive for Resilient & Sport Flooring Installation

Special features

  • permanently waterproof
  • can be used indoor and outdoor
  • very high shear and tensile strength
  • achieves LEED points
  • no VOC or solvents

Product Description
R741 adhesive spreads easily and has a non-slump formula that will help insure contact and adhesive transfer because the ridges will bridge normal gaps between the flooring and substrate. It allows fast installation even with complicated patterns due to its strong green grab. There is no flash time required, so installation can commence immediately. Rolling is recommended. It offers superior flexibility and is designed to adapt to seasonal changes. R741 offers extremely high shear strength which makes it suitable for outdoor and indoor use.
Pre-Installation Checklist
A successful installation requires proper preparation of the sub floor. Read and understand all applicable guidelines and technical data sheets before beginning installation. Follow industry standards and flooring manufacturer's recommendations for sub floor preparation, design, layout and application of flooring materials.
Sub Floor Examination
Prior to installation, the sub floor must be checked according to national standards. It must be solid and sound, level, free of indentations as well as resistant to pressure and tension.
Sub Floor Preparation
Prepare sub floor according to synthetic turf manufacturer's instructions.
Installation Procedure
Spread the adhesive with the appropriate notched trowel or use a glue box to spread the adhesive onto the seaming tape. Lay the turf into the adhesive and press down firmly.
Storage
Place plastic on top of unused adhesive. Remove air pockets between adhesive and plastic. Place silica bags in pail. Place lid on pail and seal tightly. Store pail in a cool dry place.

Limitations
When using other than STAUF products in conjunction with STAUF primers, sealers, leveling compounds, or adhesives, STAUF denies any and all responsibility for any ensuing problems and/or damages without prior written authorization from STAUF.
Do not install during heavy rain or where water has accumulated.
Do not install below 32°F (0°C) or above 100°F (38°C). Use only on approved seaming tapes.
In case of accident, injury, spill or exposure, see SDS sheet for information. Consult technical data sheet at www.staufusa.com for updated information.
The foregoing representations are based on the results of our most current product and material testing within a controlled environment and are of a non-obligatory advisory nature only. As such, they do not constitute an express or implied warranty of any kind including the Warranty of Merchantability and/or Fitness for a Particular Purpose. Because we have no control over the actual quality of workmanship, materials used and worksite conditions, STAUF USA, LLC. will in no event be liable for any incidental and/or consequential damages. herefore, we strongly recommend that prior on-site testing be conducted to refer to and study the suitability of the product for the intended purpose. With the release of this technical information sheet all its prior versions become invalid. For warranty and warranty disclaimer information please see our Limited Lifetime Warranty @ www.staufusa.com
General Features
  • contains no water
  • contains no chlorinated solvents
  • contains no solvents
  • contains no VOC (calc. per CA Rule 1168)
  • nonflammable
  • high solids content
  • ozone friendly
  • high strength moisture cured urethane
  • Freeze/thaw stable
Installation Features
  • wet lay - no flash time required
  • strong green grab
  • non-slump formula
  • bridges normal sub floor variations
  • very low odor
  • excellent spread rate
  • spreads easily
  • higher temp will shorten drying time
Long Term Features
  • resistant against aging
  • suitable for radiant heat systems
  • adhesive is waterproof when cured
  • No health hazards
Approved Flooring
  • Synthetic Turf
  • Sports Flooring
  • Vinyl Tiles and Planks (VCT, LVT, SVT, LVP, VET)
  • Rubber Flooring
  • Linoleum
  • Carpet (felt, fiber, jute, woven vinyl)
  • Wall/Cove base
  • Rubber Flooring
  • Underlayments
  • Cork Flooring
  • NOT approved: Polyolefin/Polyethylen/Polypropylen backed Flooring
Approved Materials
  • Synthetic Turf
  • Sports Flooring
Approved Sub Floors
  • Concrete Slabs
  • Seaming Tape
  • Asphalt
Approved Substrates
  • Concrete Slabs
  • OSB (underlayment grade)
  • Plywood (underlayment grade)
  • Felt backed Sheet Vinyl (well bonded, sanded, asbestos-free)
  • Ceramic Tiles
  • Stone, Terrazzo
  • Cured Leveling Compounds
  • Radiant Heated Sub Floors
  • Seaming Tape
  • Metal Floors
  • Asphalt
  • Wet Concrete Slab up to 25#/24hrs/1,000SF and 100% RH
  • Epoxy Sealers (100% solid, cured)
  • Stained Concretes (well bonded)
Flash Time (wet lay)
  • no
Open Time (wet lay)
  • approx. 45 mins @ 70°F (21°C)
Approved Primers
  • Primer is normally not required
  • STAUF AQP-200 Eco-Prime
Approved Sealers
  • Sealer is normally not required
  • STAUF ACS-210 True-Seal
  • STAUF ERP-270 Perma-Seal
Approved Leveling Compounds
  • Leveling is normally not required
Approved Trowels and Spread Rate
  • Flat backed Material-#1 (1/16"x1/16"x1/16" V notch) up to 170 SF/gal.
  • Rough backed Material-#2 (1/8"x1/8"x1/16" V notch) up to 90 SF/gal.
  • Trowel #4 (Outdoor on rough Surface): up to 50 SF/gal.
  • Recommended Run Length: 160 LF/unit (glue 9" wide)
  • Sports Flooring-#15 (3/32"x3/32"x3/32") up to 130 SF/gal.
Cure Time until Normal Traffic
  • approx. 24 hours
Clean-Up
  • Use acetone while wet
Temperature Range during Installation
  • 32-100F
Relative Humidity Range during Installation
  • 20% - 90%
Packaging Size
  • 3 gal. Plastic Pail
Color
  • Cream
pH value of concrete
  • resistent up to 14
Shelf Life
  • 12 Months in original, unopened container
Shear Strength
  • 580 psi (4.0 N/mm²) after 7 days
Open Time30% R/H50% R/H80% R/H
50�F/10�C60 min. 50 min. 40 min. 
70�F/21�C50 min. 40 min. 30 min. 
90�F/32�C40 min. 30 min. 20 min. 
Revision: 2018-11-28 16:25:10

Please enter the email address of the person to whom you would like to send this PDF.